ETAP Power System Analysis For Electrical Engineers

Learn ETAP, Power System Analysis and Supporting Hand Calculations From ETAP Expert

What you'll learn:

• Fundamentals of Power System Analysis
• Design and Simulate Electrical Power System Using ETAP 19.5 Software
• Creating New Project in ETAP
• Understanding ETAP Software Overview & Toolbars
• Create Single Line Diagram in ETAP With Conventional Modelling Method & Auto-Build (Time Saving)
• Load Flow Analysis - Theory, Comparison of Hand Calculations and ETAP Results
• Load Flow Analysis Example
• Cable Sizing Analysis
• Transformer MVA Sizing
• Generator Load Sharing
• Transformer X/R Ratio Calculation
• Short Circuit Analysis - Theory, Comparison of Hand Calculations and ETAP Results
• Short Circuit Analysis - Vendor Type Testing of Medium and Low Voltage Circuit Breaker (IEC Standard)
• Short Circuit Analysis Example
• Protection Coordination (Relay Coordination) Analysis - Theory
• Protection Coordination Analysis Example
• Protection Coordination Analysis - Auto Star Evaluation
• Arc Flash Analysis Fundamentals Using IEEE:1584-2002 Standard
• Arc Flash Analysis Example
• Motor Starting Analysis with Dynamic, Static, Auto-transformer, Star-Delta Starting
• Motor Starting Analysis Examples Dynamic, Static, Auto-transformer, Star-Delta Starting
• Transient Stability Analysis
• Transient Stability Examples - Load addition/rejection, 3-Phase fault, Under-Frequency Load Shedding etc
• Harmonic Analysis & Example
• Ground Grid Analysis & Example
• Faulted Motor Transients

"Want To Become Expert In ETAP Software and Power System?" This course will help you to achieve your goals to become ETAP and Power System Expert.

Welcome to the course "ETAP Power System Analysis For Electrical Engineers"

ETAP is an analytical engineering software which is helpful for an electrical engineer to simulate and analyze the steady state and dynamic power system. It is used by various sectors such as Generation, Transmission, Distribution, Industrial, Transportation and Low voltage.

The purpose of this course is to learn power system modeling & analysis using ETAP software which will cover a range of ETAP functionalities used to design & solve various power system practical problems.

The course will begin with the software overview, basics of one-line diagram creation, data entry, and quickly expands the users’ knowledge to include methods to automatically perform multiple ‘what if’ studies using multiple scenarios. Wherever possible, the topics are explained with hand calculations and results are compared with ETAPsoftware so that it becomes more easier to the attendees to understand the concepts.

Below major topics are covered in this course:

• Load Flow Analysis With Supporting Hand Calculations

• Cable Ampacity and Sizing

• Transformer MVASizing

• Short Circuit Analysis With Supporting Hand Calculations

• Protection &Coordination Analysis

• Arc Flash Analysis Using IEEE:1584-2002 Standard

• Motor Starting Analysis

  • Dynamic Motor Starting

  • Static Motor Starting

  • Star-Delta Motor Starting

  • Auto-Transformer Motor Starting

  • Impedance Method for Voltage Drop Calculation

• Transient Stability Analysis

  • Load Addition

  • Load Rejection

  • Faulted Transients

  • Multiple Generator Transient Stability

  • Under-Frequency Load Shedding

  • D-QAxis Modelling

  • Swing Equation Derivation

  • Derivation of Inertia

• Harmonic Analysis

• Ground Grid Analysis

Benefits of attending this course:

1. Course is published using ETAP 19.5 and ETAP20.6

2. ETAPsoftware generated results are supported with Hand Calculations

3. Downloadable course material and Hand Calculations